Subaru Legacy 2002 Service Manual page 2241

Power Assisted System (Power Steering)
13) Using a sharp pointed pliers, rotate the rack
stopper in the direction of the arrow until the end
of the circlip comes out of the stopper. Rotate the
circlip in the opposite direction and pull it out.
(1) Rack stopper
14) Pull rack assembly from cylinder side, and
draw out rack bushing and rack stopper together
with rack assembly.
CAUTION:
Be careful not to contact rack to inner wall of
cylinder when drawing out. Any scratch on cyl-
inder inner wall will cause oil leakage.
(1) Rack bushing
(2) Rack ASSY
(3) Rack stopper
15) Remove rack bushing and rack stopper from
rack assembly.
CAUTION:
Do not reuse removed rack bushing and circlip.
STEERING GEARBOX [LHD MODEL]
S4M0158B
S4M0402A
PS-32
16) Insert ST from pinion housing side and
remove oil seal using a press.
ST 34199AE050 OIL SEAL REMOVER
(1) Press
(2) Oil seal
NOTE:
Discard removed oil seal.
2. CONTROL VALVE ASSEMBLY
NOTE:
Parts requiring replacement are described in the
smallest unit of spare parts including damaged
parts and spare parts damaged. In actual disas-
sembly work, accidental damage as well as inevi-
table damage to some related parts must be taken
into account, and spare parts for them must also
be prepared. However, it is essential to pinpoint the
cause of trouble, and limit the number of replace-
ment parts as much as possible.
S4M0163B
S601272A0602