Subaru Legacy 2002 Service Manual page 2250

14) Install gasket on valve assembly. Insert valve
assembly into place while facing rack teeth toward
pinion.
CAUTION:
Be sure to use a new gasket.
NOTE:
Do not allow packing to be caught when installing
valve assembly.
(1) Valve ASSY
15) Tighten bolts alternately to secure valve
assembly.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
CAUTION:
Be sure to alternately tighten bolts.
16) Apply grease to sleeve insertion hole.
17) Apply grease to dust seal insertion hole.
CAUTION:
Apply clean grease with clean hands. If mate-
rial having a sharp edge is used for applying
grease, oil seal at the inside might be damaged.
18) Apply grease to sliding surface of sleeve and
spring seat, then insert sleeve into pinion housing.
Fit spring into sleeve screw, pack grease inside of
screw, then install the screw.
(1) Adjusting screw
(2) Spring
(3) Sleeve
STEERING GEARBOX [LHD MODEL]
S4M0155B
B4M1129B
PS-41
Power Assisted System (Power Steering)
19) Rack and pinion backlash adjustment
(1) Loosen adjusting screw.
(2) Rotate input shaft so that rack is in the
straight ahead direction.
(3) Apply grease to sleeve.
(1) Adjusting screw
(2) Lock nut
(3) Spring
(4) Sleeve
(4) Tighten adjusting screw by two threads.
(5) Apply liquid packing to at least 1/3 of entire
perimeter of adjusting screw thread.
Liquid packing:
THREE BOND 1141
(1) Apply liquid packing to at least 1/3 of entire perim-
eter.
(6) Tighten adjusting screw to 7.4 N·m (0.75
kgf-m, 5.4 ft-lb) and back off 25°.
B4M1130B
G4M0121
S4M0385A