Subaru Legacy 2002 Service Manual page 1922

6. REAR WHEEL TOE-IN
¼ Inspection
1) Using a toe-in gauge, measure rear wheel toe-
in.
Toe-in:
0±3 mm (0±0.12 in)
2) Mark rear sides of left and right tires at height
corresponding to center of spindles and measure
distance "A" between marks.
3) Move vehicle forward so that marks line up with
front sides at height corresponding to center of
spindles.
4) Measure distance "B" between left and right
marks. Toe-in can then be obtained by the follow-
ing equation:
A − B = Toe-in
NOTE:
When left and right wheels are adjusted for toe-in at the same time, the movement of one scale gradua-
tion changes toe-in by approximately 3 mm (0.12 in).
Toe-in is increased.
Toe-in is decreased.
3) Tighten self-locking nut.
WHEEL ALIGNMENT
S202116A1007
H4M1279B
Left side
Rotate clockwise.
B4M1787
Rotate counterclock-
wise.
B4M1786
FS-11
¼ Adjustment
1) Loosen self-locking nut on inner side of link
rear.
CAUTION:
¼ When loosening or tightening adjusting bolt,
hold bolt head and turn self-locking nut.
¼ Discard
loosened
replace with a new one.
(1) Adjusting bolt
(2) Link rear
2) Turn adjusting bolt head until toe-in is at the
specification.
B4M1786
B4M1787
Tightening torque:
120 N·m (12.2 kgf-m, 88 ft-lb)
Front Suspension
self-locking nut and
B4M1785B
Right side
Rotate counterclock-
wise.
Rotate clockwise.