Subaru Legacy 2002 Service Manual page 1605

Automatic Transmission
NOTE:
When removing outlet pipe, be careful not to lose
balls and springs used with retaining screws.
17) Remove front and rear vehicle speed sensor
and torque converter turbine speed sensor.
¼ Front vehicle speed sensor and torque con-
verter turbine speed sensor
(A) Front vehicle speed sensor
(B) Torque converter turbine speed sensor
¼ Rear vehicle speed sensor
(A) Rear vehicle speed sensor
(B) Front vehicle speed sensor
18) Remove oil pan.
19) Disconnect duty solenoids and ATF tempera-
ture sensor connectors. Remove connectors from
clip and disconnect connectors at 9 places.
FRONT VEHICLE SPEED SENSOR
B3M1066B
B3M1056B
AT-34
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Transmission ground
20) Remove harness assembly.
B: INSTALLATION
1) Pass the harness assembly through the hole in
the transmission case.
B2M2263I
S502709A11
B3M1067