Subaru Legacy 2002 Service Manual page 1746

2) Install clutch cover on flywheel and tighten bolts
to the specified torque.
NOTE:
¼ Align matching marks.
¼ Note the front and rear of the clutch disc when
installing.
¼ Tighten clutch cover installing bolts gradually.
Each bolt should be tightened to the specified
torque in a crisscross fashion.
Tightening torque:
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
3) Remove ST.
ST 499747100 CLUTCH DISC GUIDE
2. EXCEPT EUROPE AND AUSTRALIA
MODELS
S504252A1104
1) Insert ST into the clutch disc and install them on
the flywheel by inserting the ST end into the pilot
bearing.
NOTE:
When installing clutch disc, be careful its direction.
ST 499747100 CLUTCH DISC GUIDE
(A) Flywheel side
2) Install clutch cover on flywheel and tighten bolts
to the specified torque.
NOTE:
¼ When installing the clutch cover on the flywheel,
position the clutch cover so that there is a gap of
120° or more between "0" marks on the flywheel
and clutch cover. ("0" marks indicate the directions
of residual unbalance.)
CLUTCH DISC AND COVER
¼ Note the front and rear of the clutch disc when
installing.
¼ Temporarily tighten bolts by hand. Each bolt
should be tightened to the specified torque in a
crisscross fashion.
Tightening torque:
B2M3346A
3) Remove ST.
ST 499747100 CLUTCH DISC GUIDE
4) Install transmission assembly. <Ref. to MT-33
INSTALLATION, Manual Transmission.>
C: INSPECTION
1. CLUTCH DISC
1) Facing wear
Measure the depth of rivet head from the surface
of facing. Replace if facings are worn locally or
worn down to less than the specified value.
Depth of rivet head:
B2M4608A
CL-13
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
(A) "0" marks
S504252A10
S504252A1001
Limit of sinking
0.3 mm (0.012 in)
Clutch System
B2M1011B