Subaru Legacy 2002 Service Manual page 1616

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
1. TRANSFER DUTY SOLENOID AND
TRANSFER VALVE BODY
1) Install transfer duty solenoid and transfer valve
body.
(1) Install transfer duty solenoid and transfer
valve body.
Tightening torque:
T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)
(2) Connect transfer duty solenoid connector.
(A) Transfer valve body
(B) Transfer duty solenoid connector
(C) Transfer duty solenoid
2) Install extension case to transmission case.
(1) Tighten 11 bolts.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(2) Adjust the select cable. <Ref. to CS-11,
ADJUSTMENT, Select Cable.>
3) Install rear vehicle speed sensor.
Tightening torque:
T: 7 N·m (0.7 kgf-m, 5.1 ft-lb)
S502227A1101
B3M1045G
B3M1043A
AT-45
4) Install transmission rear crossmember.
(1) Tighten bolts.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51 ft-lb)
(2) Lower and remove transmission jack.
5) Install propeller
INSTALLATION, Propeller Shaft.>
6) Install front, center rear exhaust pipe and muf-
fler.
Except 3.0 L model
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust Pipe.>, <Ref.
INSTALLATION, Rear Exhaust Pipe.> and <Ref. to
EX(w/oOBD)-14, INSTALLATION, Muffler.> or
<Ref. to EX-6, INSTALLATION, Front Exhaust
Pipe.>, <Ref. to EX-9, INSTALLATION, Rear
Exhaust Pipe.> and
INSTALLATION, Muffler.>
3.0 L model
<Ref. to EX(H6)-6, INSTALLATION, Front Exhaust
Pipe.>, <Ref. to EX(H6)-8, INSTALLATION, Rear
Exhaust Pipe.> and
INSTALLATION, Muffler.>
7) Lower and remove jack.
8) Connect transmission harness connector.
Automatic Transmission
B2M3407A
shaft. <Ref. to DS-14,
to EX(w/oOBD)-13,
<Ref. to EX-10,
<Ref. to EX(H6)-9,
S2M0212