Subaru Legacy 2002 Service Manual page 2266

7) Slowly press inner side oil seal until distance
between ST and end of rack is 65 mm (2.56 in).
ST 34199AE000 GUIDE (Oil seal)
CAUTION:
Ensure ST's inner wall is free of scratches.
Otherwise, it may damage oil seal during instal-
lation.
(1) Rack piston
(2) Inner side oil seal
(3) Back-up ring
8) Pass ST2 and pipe through rack and press
outer side oil seal until ST1 is in contact with ST2.
ST1 34199AE000 GUIDE (Oil seal)
ST2 34199AE010 INSTALLER (Oil seal)
(1) Pipe
(2) Outer side oil seal
STEERING GEARBOX [RHD MODEL]
S4M0431A
S4M0432A
PS-57
Power Assisted System (Power Steering)
9) Install holder from cylinder side of steering
body.
Tightening torque:
64±5 N·m (6.5±0.5 kgf-m, 47.0±3.6 ft-lb)
10) Attach ST to rack cylinder. Using a press,
install back-up ring and oil seal.
NOTE:
Press ST until its groove is aligned with end of
holder.
ST 34099FA030 INSTALLER & REMOVER
(1) Installer guide
(2) Holder
(3) Rack piston
(4) Oil seal
(5) Back-up ring
G4M0820
S4M0433A