Control Systems
3. Select Cable
A: REMOVAL
S501549A18
1) Set the vehicle on a lift.
2) Prior to removal, set lever to "N" position.
3) Lift-up the vehicle.
4) Remove front, center, rear exhaust pipe and
muffler.
Except 3.0 L model
<Ref.
to
EX(w/oOBD)-9,
Exhaust
Pipe.>,
<Ref.
REMOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(w/oOBD)-14, REMOVAL, Muffler.> or <Ref. to
EX-5, REMOVAL, Front Exhaust Pipe.>, <Ref. to
EX-9, REMOVAL, Rear Exhaust Pipe.> and <Ref.
to EX-10, REMOVAL, Muffler.>
3.0 L model
<Ref. to EX(H6)-5, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H6)-8, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H6)-9, REMOVAL,
Muffler.>
5) Remove heat shield cover.
6) Remove snap pin and washer from range
select lever.
(A)
Range select lever
(B)
Snap pin
(C)
Select cable
(D)
Clamp
(E)
Washer
SELECT CABLE
S501549
REMOVAL,
Front
to
EX(w/oOBD)-13,
B3M1605
B3M1029D
7) Remove plate assembly from transmission
case.
(A)
Select cable
(B)
Plate ASSY
(C)
Clamp
8) Disconnect cable from select lever and then
remove cable bracket.
(A)
Adjusting nuts
(B)
Cable bracket
9) Remove select cable from plate assembly.
CS-10
B3M1030E
B3M1795A