Subaru Legacy 2002 Service Manual page 1666

B: INSTALLATION
1. BACK-UP LIGHT SWITCH AND
NEUTRAL POSITION SWITCH
1) Install back-up light switch and neutral position
switch with harness.
Tightening torque:
24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Neutral switch
(B) Back-up light switch
2) Connect connector of back-up light switch and
neutral position switch.
3) Install air intake duct and cleaner case. <Ref. to
IN-6, INSTALLATION, Air Cleaner Case.> and
<Ref. to IN-7, INSTALLATION, Air Intake Duct.>
4) Connect battery ground cable.
2. HIGH-LOW SWITCH
1) Install high-low switch.
Tightening torque:
24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
2) Install HI-LO switch cable to the clamp.
3) Connect connector high-low switch.
4) Install air intake duct and cleaner case. <Ref. to
IN-6, INSTALLATION, Air Cleaner Case.> and
<Ref. to IN-7, INSTALLATION, Air Intake Duct.>
5) Connect battery ground cable.
C: INSPECTION
1. BACK-UP LIGHT SWITCH
Inspect the back-up light switch. <Ref. to LI-7,
INSPECTION, Back-up Light System.>
SWITCHES AND HARNESS
S503232A11
S503232A1101
B3M1372C
S503232A1102
S503232A10
S503232A1001
2. NEUTRAL POSITION SWITCH
1) Turn ignition switch to OFF.
2) Disconnect connector neutral position switch.
3) Measure resistance between neutral position
switch terminals.
Gear shift position
Neutral position
Other positions
4) Replace defective parts.
3. HIGH-LOW SWITCH
1) Turn ignition switch to OFF.
2) Disconnect connector high-low switch.
3) Measure resistance
switch terminals.
Gear shift position
Lo position
Hi position
4) Replace defective parts.
MT-41
Manual Transmission and Differential
Specified resis-
Terminal No.
Less than 1 Ω
1 and 2
More than 1 MΩ
S503232A1003
between HIGH-LOW
Specified resis-
Terminal No.
Less than 1 Ω
1 and 2
More than 1 MΩ
S503232A1002
tance
OBD0469
tance
B3M2134