Subaru Legacy 2002 Service Manual page 1594

6) Tighten nuts and bolts which hold lower side of
transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
Except 3.0 L model
3.0 L model
7) Lower the vehicle.
8) Connect engine and transmission.
(1) Remove ST from torque converter clutch
case.
NOTE:
Be careful not to drop the ST into the torque con-
verter clutch case when removing ST.
ST 498277200 STOPPER SET
(2) Install starter.
Except 3.0 L model
<Ref. to SC-6, INSTALLATION, Starter.>
3.0 L model
<Ref. to SC(H6)-6, INSTALLATION, Starter.>
AUTOMATIC TRANSMISSION ASSEMBLY
B3M2047
B3M2048
(3) Tighten bolt which holds right upper side of
transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
Except 3.0 L model
3.0 L model
9) Install torque converter clutch to drive plate.
(1) Tighten bolts which hold torque converter
clutch to drive plate.
(2) Tighten other bolts while rotating the engine
by using ST.
NOTE:
Be careful not to drop bolts into torque converter
clutch housing.
2.0 L model
ST 499977300 CRANK PULLEY WRENCH
Except 2.0 L model
ST 499977100 CRANK PULLEY WRENCH
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
AT-23
Automatic Transmission
B3M2044
B3M2045
S2M0207