Oil Pump - Subaru Legacy 2002 Service Manual

Hide thumbs Also See for Legacy 2002:

Table of Contents

Power Assisted System (Power Steering)

8. Oil Pump

1. EXCEPT 3.0 L MODEL

1) Remove ground cable from battery.

2) Remove pulley belt cover bracket.

3) Loosen lock bolt and slider bolt and remove

power steering pump drive V-belt.

4) Disconnect connector from power steering

pump switch.

5) Disconnect pipe C and suction hose from oil

¼ Do not allow fluid from the hose end to come

into contact with pulley belt.

¼ To prevent foreign matter from entering the

hose and pipe, cover the open ends of them

with a clean cloth.

Suction hose

S601070A1803

6) Remove bolts which install power steering

pump bracket.

7) Place oil pump bracket in a vise, remove two

bolts from the front side of oil pump.

Do not place oil pump bracket directly in the

vise; use soft pads and hold oil pump lightly to

protect the pump.

8) Remove socket from oil pump.

9) Remove bolt from the rear side of oil pump.

Table of Contents