Subaru Legacy 2002 Service Manual page 2193

Hide thumbs Also See for Legacy 2002:

Table of Contents

S405541A0602

1) Remove the brake switch.

2) Unbolt, and then remove the brake pedal.

3) Remove bushing, spacer and spring.

Brake spacer

Brake pedal spring

4) Remove the brake pedal pad.

1) Attach stop light switch, etc. to pedal bracket

temporarily.

2) Clean inside of bores of clutch pedal and brake

pedal, apply grease, and set bushings into bores.

3) Align bores of pedal bracket, clutch pedal and

brake pedal, attach brake pedal return spring and

clutch pedal effort reducing spring (vehicle with hill

holder), and then install pedal bolt.

Clean up inside of bushings and apply grease

before installing spacer.

Tightening torque:

T: 29 N·m (3.0 kgf-m, 21.7 ft-lb)

4) Set brake pedal position by adjusting position of

stop light switch.

Pedal position: L

126.4 mm (4.98 in)

154.9 mm (6.10 in)

Tightening torque:

T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)

Chapters

Table of Contents