Subaru Legacy 2002 Service Manual page 2069

Drive Shaft System
CAUTION:
¼ Use a new axle nut for rear use only (Olive
color).
¼ Always tighten axle nut before installing
wheel on vehicle. If wheel is installed and
comes in contact with ground when axle nut is
loose, wheel bearings may be damaged.
¼ Be sure to tighten axle nut to specified
torque. Do not overtighten it as this may dam-
age wheel bearing.
11) Install wheel and tighten wheel nuts to speci-
fied torque.
Tightening torque:
88 N·m (9 kgf-m, 65 ft-lb)
C: DISASSEMBLY
1) Using ST, remove hub unit from hub assembly.
CAUTION:
Securely set hub assembly so that it does not
lean.
ST 398507703 DUMMY COLLAR
HUB UNIT BEARING
B4M1691
S301155A06
B4M1686A
DS-24
2) Using ST and a puller (common hand tool),
remove bearing inner race.
ST1 399520105 SEAT
ST2 927080000 HUB STAND
CAUTION:
¼ Do not remove hub unit bearing unless dam-
aged.
¼ Do not re-use hub unit bearing after removal.
3) Using ST, press hub bolt out.
ST 927080000 HUB STAND
CAUTION:
Be careful not to hammer hub bolts. This may
deform hub.
B4M1687A
G4M0228