Subaru Legacy 2002 Service Manual page 2305

ABS (Diagnostics)
No.
3 PERFORM THE GENERAL DIAGNOSTICS.
1) Inspect using "General Diagnostics Table".
<Ref. to ABS-157, General Diagnostics
Table.>
2) Perform the clear memory mode. <Ref. to
ABS-17, CLEAR MEMORY MODE,
OPERATION, Subaru Select Monitor.>
3) Perform the inspection mode. <Ref. to
ABS-20, Inspection Mode.>
4) Calling up the diagnostic trouble code
(DTC). <Ref. to ABS-16, READ DIAGNOSTIC
TROUBLE CODE, OPERATION, Subaru
Select Monitor.>
4 PERFORM THE DIAGNOSIS.
1) Inspect using "Diagnostics Chart with
Subaru Select Monitor". <Ref. to ABS-82,
Diagnostics Chart with Subaru Select Moni-
tor.>
NOTE:
For diagnostic trouble code (DTC) list, refer to
"List of Diagnostics Trouble Code (DTC)".
<Ref. to ABS-23, WITHOUT SUBARU
SELECT MONITOR, LIST, List of Diagnostics
Trouble Code (DTC).>
2) Repair trouble cause.
3) Perform the clear memory mode. <Ref. to
ABS-17, CLEAR MEMORY MODE,
OPERATION, Subaru Select Monitor>
4) Perform the inspection mode. <Ref. to
ABS-20, Inspection Mode.>
5) Calling up the diagnostic trouble code
(DTC). <Ref. to ABS-16, READ DIAGNOSTIC
TROUBLE CODE, OPERATION, Subaru
Select Monitor.>
BASIC DIAGNOSTIC PROCEDURE
Step
Is no diagnostic trouble
code (DTC) designated and
ABS warning light goes out
after turning on?
Is no diagnostic trouble
code (DTC) designated and
does ABS warning light go
out after turning on?
ABS-4
Check Yes
Complete the
diagnosis.
Complete the
diagnosis.
No
Go to step 4.
Inspect using
"Diagnostics Chart
with Subaru
Select Monitor".
<Ref. to ABS-82,
Diagnostics Chart
with Subaru
Select Monitor.>