Subaru Legacy 2002 Service Manual page 1700

MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
10) Install the rest parts to the rear section of
transmission main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
(A) Needle bearing
(B) 5th drive gear
(C) Baulk ring
(D) 5th-Rev sleeve and hub ASSY
(E) Lock washer
(F) Lock nuts
11) Tighten lock nuts to the specified torque using
ST1 and ST2.
NOTE:
Secure lock nuts in two places after tightening.
ST1 499987003 SOCKET WRENCH
ST2 498937000 TRANSMISSION HOLDER
Tightening torque:
118 N·m (12.0 kgf-m, 86.8 ft-lb)
12) Install needle bearing on main shaft.
13) Install the parts to the front section of trans-
mission main shaft.
NOTE:
¼ Be careful not to damage the graded section of
transmission main shaft when installing needle
bearing.
¼ Face the grooved side toward input gear.
¼ Align high-low baulk ring's groove with shifting
insert.
B3M1371A
(A)
(B)
(C)
(D)
(E)
(F)
(G) Sleeve and hub ASSY
14) Install new snap ring to the rod section of
transmission main shaft using ST1 and ST2.
NOTE:
Select a suitable outer snap ring so that axial clear-
ance between snap ring and hub is held within
0.060 to 0.100 mm (0.0024 to 0.0039 in).
ST1 499757002 INSTALLER
ST2 499757001 SNAP RING GUIDE
MT-75
Manual Transmission and Differential
Ball
Input low gear spacer
Needle bearing
Low input gear
Friction damper
High-low baulk ring
Snap ring
Part No. Thickness mm (in)
805025051
805025052
805025053
805025054
805025055
805025056
805025057
805025058
S3M0169B
2.42 (0.0953)
2.47 (0.0972)
2.52 (0.0992)
2.57 (0.1012)
2.62 (0.1031)
2.67 (0.1051)
2.72 (0.1071)
2.37 (0.0933)