Subaru Legacy 2002 Service Manual page 1929

Front Suspension
B: INSTALLATION
1) Install strut mount at upper side of strut to body
and tighten with nuts.
Tightening torque:
20 N·m (2.0 kgf-m, 14.5 ft-lb)
2) Position aligning mark on camber adjustment
bolt with aligning mark on lower side of strut.
CAUTION:
¼ While holding head of adjusting bolt, tighten
self-locking nut.
¼ Be sure to use new self-locking nut.
Tightening torque:
175 N·m (17.8 kgf-m, 129 ft-lb)
3) Install ABS sensor harness to strut.
Tightening torque:
32 N·m (3.3 kgf-m, 23.9 ft-lb)
4) Install bolts which secure brake hose to strut.
Tightening torque:
32 N·m (3.3 kgf-m, 23.9 ft-lb)
5) Install wheels.
NOTE:
Check wheel alignment and adjust if necessary.
FRONT STRUT
S202115A11
FS-18
C: DISASSEMBLY
1) Using a coil spring compressor, compress coil
spring.
2) Using ST, remove self-locking nut.
ST 927760000 STRUT MOUNT SOCKET
3) Remove strut mount, upper spring seat and
rubber seat from strut.
4) Gradually decreasing compression force, and
remove coil spring.
5) Remove dust cover and helper spring.
S202115A06
S4M0095
S4M0096A