Mt Drive Select Lever - Subaru Legacy 2002 Service Manual

5. MT Drive Select Lever

A: REMOVAL
S501235A18
1) Set drive select lever to HI position.
2) Remove the knob.
(A) Drive select lever knob
3) Remove console
REMOVAL, Console Box.>
4) Remove the bolt installing drive select lever
assembly on body.
5) Remove flange nut, clip and then disconnect
the cable from lever assembly.
(A) Flange nut
(B) Lever ASSY
(C) Clip
MT DRIVE SELECT LEVER
S501235
B3M1514A
box. <Ref. to EI-34,
G3M0766
B3M1846A
B: INSTALLATION
1) Install drive select lever.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
2) Set drive select lever to HI position.
(A) HI position
3) Be sure to insert cable eye end bolt into lever
arm slit.
(A) Cable eye end bolt
(B) Lever arm
4) Tighten nut where cable end bolt comes to a
stop.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
5) Install in the reverse order of removal.
CS-19
Control Systems
S501235A11
B3M1516A
B3M1517A