Subaru Legacy 2002 Service Manual page 1606

2) Connect harness connectors at 9 places.
Connect connectors of same color, and secure
connectors to valve body sing clips.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Transmission ground
3) Apply proper amount of liquid gasket to the
entire oil pan mating surface.
Fluid packing:
THREE BOND 1217B
FRONT VEHICLE SPEED SENSOR
B2M2263I
B3M1040
AT-35
4) Apply liquid gasket fully to 3 holes other than
screw holes on the transmission case.
Fluid packing:
THREE BOND 1217B
5) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
6) Install the front and rear vehicle speed sensor,
and also the torque converter turbine speed
sensor, and then fasten the harness.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
7) Install oil cooler outlet pipe.
NOTE:
Be sure to use a new aluminum washer.
Tightening torque:
T1: 44 N·m (4.5 kgf-m, 32.5 ft-lb)
T2: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
8) Install transmission rear crossmember bolts.
Tightening torque:
70 N·m (7.1 kgf-m, 51 ft-lb)
9) Install propeller
INSTALLATION, Propeller Shaft.>
10) Install shield cover.
Automatic Transmission
B3M2265
B3M2059A
shaft. <Ref. to DS-14