Operating Cylinder - Subaru Legacy 2002 Service Manual

5. Operating Cylinder

A: REMOVAL
S504253A18
1) Remove air cleaner case.
<Ref. to IN-6, REMOVAL, Air Cleaner Case.>
2) Remove clutch hose from operating cylinder.
CAUTION:
Cover hose joint to prevent clutch fluid from
flowing out.
(A) Clutch hose
(B) Operating cylinder
3) Remove operating cylinder from transmission.
OPERATING CYLINDER
B: INSTALLATION
S504253
1) Install in the reverse order of removal.
NOTE:
Before installing operating cylinder, apply grease
(SUNLIGHT 2: P/N 003602010) to contact point of
release lever and operating cylinder.
Tightening torque:
B2M1179J
2) After bleeding air from operating cylinder,
ensure that clutch operates properly.
<Ref. to CL-26, Clutch Fluid Air Bleeding.>
C: INSPECTION
1) Check operating cylinder for damage. If operat-
ing cylinder is damaged, replace it.
2) Check operating cylinder for fluid leakage or
damage on boot. If any leakage or damage is
found, replace operating cylinder.
B2M1263
CL-21
S504253A11
T1: 18 N·m (1.8 kgf-m, 13.0 ft-lb)
T2: 37 N·m (3.8 kgf-m, 27.5 ft-lb)
S504253A10
Clutch System
B2M1179C