Subaru Legacy 2002 Service Manual page 1595

Automatic Transmission
(3) Clog plug onto service hole.
10) Remove ST.
11) Install pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
12) Lift-up the vehicle.
Install front drive shafts into transmission.
(1) Lift-up the vehicle.
(2) Install front drive shaft into transmission.
(3) New drive spring pin into chamfered hole of
drive shaft.
13) Install ball joint into housing.
AUTOMATIC TRANSMISSION ASSEMBLY
G2M0313
H3M1839A
G2M0325
14) Connect stabilizer link to transverse link, and
temporarily tighten bolts.
NOTE:
Discard loosened self-locking nut and replace with
a new one.
Tightening torque:
T1: 30 N·m (3.1 kgf-m, 22.4 ft-lb)
T2: 50 N·m (5.1 kgf-m, 37 ft-lb)
15) Install shift select cable onto select lever.
<Ref. to CS-11, INSTALLATION, Select Cable.>
16) Install ATF level gauge guide, and connect
ATF cooler hoses to pipe.
17) Install propeller shaft.
<Ref. to DS-14, INSTALLATION, Propeller Shaft.>
18) Install heat shield cover.
19) Install rear exhaust pipe and muffler assembly.
Except 3.0 L model
AT-24
TR0291
B3M2191
B3M1605