Main Shaft Assembly For Single-Range - Subaru Legacy 2002 Service Manual

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE

Manual Transmission and Differential
4) Remove snap ring and synchro cone stopper
from 5th-Rev sleeve and hub assembly.
(A) Synchro cone stopper
(B) Snap ring
5) Using ST1, ST2 and a press, remove ball
bearing, synchro cone and baulk ring (Rev).
NOTE:
¼ Replace sleeve and hub with new ones. Do not
attempt to disassemble because they must engage
at a specified point.
disassembled, mark engagement point on splines
beforehand.
¼ Do not reuse ball bearing.
ST1 499757002 INSTALLER
ST2 498077400 SYNCHRO CONE
REMOVER
(A) Ball bearing
(B) Synchro cone
(C) Baulk ring
B3M0435B
If they should be
B3M1365A
MT-64
6) Using ST1 and ST2, remove the rest of parts.
NOTE:
Replace sleeve and hub with new ones. Do not
attempt to disassemble because they must engage
at a specified point.
disassembled, marking engagement point on
splines beforehand.
ST1 899864100 REMOVER
ST2 899714110 REMOVER
If they should be
B3M0835A