Subaru Legacy 2002 Service Manual page 1720

2) Measure backlash between bevel gear and pin-
ion. If it is not within specifications, install a suitable
washer to adjust
ADJUSTMENT, Front Differential Assembly.>
NOTE:
Be sure the pinion gear tooth contacts adjacent
gear teeth during measurement.
ST1 498247001 MAGNET BASE
ST2 498247100 DIAL GAUGE
Standard backlash:
0.13 — 0.18 mm (0.0051 — 0.0071 in)
3) Align pinion shaft and differential case at their
holes, and drive straight pin into holes from the
hypoid driven gear side, using ST.
NOTE:
Lock straight pin after installing.
ST 899904100 REMOVER
(A) Pinion shaft
(B) Differential case
(C) Straight pin
FRONT DIFFERENTIAL ASSEMBLY
it. <Ref. to MT-97,
G3M0670
B3M0609C
4) Install roller bearing to differential case.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
NOTE:
Be careful because roller bearing outer races are
used as a set.
ST1 499277100 BUSHING 1-2 INSTALLER
ST2 398497701 ADAPTER
5) Install hypoid driven gear to differential case
using twelve bolts.
Tightening torque:
T: 62 N·m (6.3 kgf-m, 45.6 ft-lb)
(A) Hypoid driven gear
(B) Differential case
MT-95
Manual Transmission and Differential
B3M0554C
G3M0671