Subaru Legacy 2002 Service Manual page 2286

4) Interconnect pipes C and suction hose.
Tightening torque:
Joint nut
39.2 N·m (4 kgf-m, 28.9 ft-lb)
CAUTION:
If a hose is twisted at this step, the hose may
come into contact with some other parts.
(1) Suction hose
(2) Pipe C
5) Connect connector to power steering oil pres-
sure switch.
6) Install pulley belt to oil pump.
7) Check pulley belt tension. <Ref. to ME-45,
V-belt.> and <Ref. to ME(H6)-29, V-belt.>
8) Tighten bolt belt tension.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
9) Install pulley belt cover bracket.
10) Connect ground terminal of battery.
11) Feed the specified power steering fluid <Ref.
PS-86, Power Steering Fluid.>
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
2. 3.0 L MODEL
S601070A1102
1) Install oil pump to bracket.
(1) Place oil pump bracket in a vise. Tighten
bushing using a 12.7 mm (1/2") type 14 and
21-mm box wrench until it is in contact with oil
pump mounting surface.
CAUTION:
Do not place oil pump bracket directly in the
vise; use soft pads and hold oil pump lightly to
protect the pump.
OIL PUMP
(1)
(2)
(3)
(4)
(5)
(2) Tighten bolt which installs oil pump to
bracket.
B4M1659B
Tightening torque:
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
Tightening torque:
37.3 N·m (3.8 kgf-m, 27.5 ft-lb)
PS-77
Power Assisted System (Power Steering)
Bushing
Nut
21 mm
14 mm
Bolt
B4M1670B
B4M2437
B4M2532