Subaru Legacy 2002 Service Manual page 2238

(1) Clamp
B: INSTALLATION
1) Insert gearbox into crossmember, being careful
not to damage gearbox boot.
2) Tighten gearbox to crossmember bracket via
clamp with bolt to the specified torque.
Tightening torque:
59 N·m (6.0 kgf-m, 43 ft-lb)
(1) Clamp
3) Connect pipes C and D to pipe of gearbox.
NOTE:
Connect lower pipe C first, and upper pipe D sec-
ond.
CAUTION:
Be careful not to damage these pipes.
(1) Pipe C
(2) Pipe D
STEERING GEARBOX [LHD MODEL]
S4M0383A
S601272A11
S4M0383A
B4M1696B
PS-29
Power Assisted System (Power Steering)
4) Install universal
INSTALLATION, Universal Joint.>
5) Connect tie-rod end and knuckle arm, and
tighten with castle nut. Fit cotter pin into the nut
and bend the pin to lock.
Castle nut tightening torque:
Tighten to 27.0 N·m (2.75 kgf-m, 19.9
ft-lb), and tighten further within 60° until
cotter pin hole is aligned with a slot in
the nut.
CAUTION:
When connecting, do not hit cap at the bottom
of tie-rod end with hammer.
(1) Castle nut
(2) Tie-rod end
(3) Knuckle arm
6) Install front stabilizer to vehicle. <Ref. to FS-21,
INSTALLATION, Front Stabilizer.>
7) Install front exhaust pipe assembly. <Ref. to
EX-6, INSTALLATION, Front Exhaust Pipe.>
8) Install tires.
9) Tighten wheel nuts to the specified torque.
Tightening torque:
88 N·m (9.0 kgf-m, 65 ft-lb)
10) Connect battery ground cable.
11) Pour fluid into oil tank, and bleed air.
<Ref. to PS-86, Power Steering Fluid.>
12) Check for fluid leaks. <Ref. to PS-46, OIL
LEAKING, INSPECTION, Steering Gearbox [LHD
Model].>
13) Install jack-up plate.
WARNING:
Be careful, exhaust manifold is hot.
14) Lower vehicle.
15) Check fluid level in oil tank.
joint. <Ref. to PS-22,
S4M0379A