Subaru Legacy 2002 Service Manual page 1690

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
D: ASSEMBLY
S503713A02
1. 2.0 L SOHC
S503713A0207
1) Assemble when each sleeve and hub assembly
are disassembled.
NOTE:
Position open ends of spring 120° apart.
2) Install 3rd drive gear, baulk ring, sleeve and hub
assembly for 3rd needle bearing on transmission
main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
3) Install 4th needle bearing race onto transmis-
sion main shaft using ST1, ST2 and a press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A)
4) Install baulk ring, needle bearing, 4th drive gear
and 4th gear thrust washer to transmission main
shaft.
NOTE:
Align baulk ring and gear & hub assembly with key
groove.
B3M1366A
(A)
(B)
MT-65
Manual Transmission and Differential
4th needle bearing race
Groove
4th gear side
B3M0543D
S3M0045A