Subaru Legacy 2002 Service Manual page 1699

MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
Manual Transmission and Differential
5) Drive ball bearing onto the rear section of trans-
mission main shaft using ST1, ST2 and a press.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
6) Using ST1 and ST2, install the 5th gear thrust
washer and 5th needle bearing race onto the rear
section of transmission main shaft.
NOTE:
Face thrust washer in the correct direction.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A) Face this surface to 5th gear side.
7) Install bearing onto synchro cone.
8) Install baulk ring and synchro cone onto 5th-
Rev sleeve and hub assembly using ST and a
press.
NOTE:
¼ Use new ball bearing.
¼ After press fitting, make sure synchro cone
rotates freely.
ST 499757002 INSTALLER
B3M0553F
(A)
(B)
(C)
9) Install synchro cone stopper and snap ring to
5th-Rev sleeve and hub assembly.
B3M0091D
(A)
(B)
MT-74
Baulk ring
Synchro cone
Ball bearing
Synchro cone stopper
Snap ring
B3M1370A
B3M0435B