Subaru Legacy 2002 Service Manual page 1701

MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
Manual Transmission and Differential
2. EXCEPT 2.0 L
S503714A0203
1) Assemble when each sleeve and hub assembly
are disassembled.
NOTE:
Position open ends of spring 120° apart.
(A) High-low coupling sleeve
(B) Shifting insert
(C) High-low synchronizer spring
(D) High-low synchronizer hub
(E) Sleeve
(F) Insert key
(G) 3rd-4th synchronizer hub
(H) Sleeve
(I) Insert key
(J) 5th-Rev synchronizer hub
2) Install 3rd drive gear, inner baulk ring, outer
baulk ring, synchro cone sleeve and hub assembly
for 3rd needle bearing on transmission main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
3) Install 4th needle bearing race onto transmis-
sion main shaft using ST1, ST2 and a press.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A)
S3M0444A
4) Install baulk ring, needle bearing, 4th drive gear
and 4th gear thrust washer to transmission main
shaft.
NOTE:
Face thrust washer in the correct direction.
(A)
(B)
5) Drive ball bearing onto the rear section of trans-
mission main shaft using ST1, ST2 and a press.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
B3M0837A
MT-76
4th needle bearing race
Groove
4th gear side
B3M0543D
S3M0045A
B3M0553F