Shift Solenoids, Duty Solenoids And Atf Temperature Sensor - Subaru Legacy 2002 Service Manual

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR

<Ref. to EX(w/oOBD)-13,
Exhaust Pipe.> and <Ref. to EX(w/oOBD)-14,
REMOVAL, Muffler.> or <Ref. to EX-9, REMOVAL,
Rear Exhaust Pipe.> and <Ref. to EX-10,
REMOVAL, Muffler.>
3.0 L model
<Ref. to EX(H6)-8, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H6)-9, REMOVAL, Muf-
fler.>
7) Raise vehicle and drain ATF.
(A) Oil pan
(B) Drain plug
(C) Deferential oil drain plug
8) Remove heat shield cover.
9) Remove propeller shaft. <Ref. to DS-13,
REMOVAL, Propeller Shaft.>
10) Remove transmission rear crossmember.
(1) Support transmission using a transmission
jack and raise slightly.
(2) Remove bolts and nuts as shown in Figure.
11) Remove rear vehicle speed sensor.
REMOVAL, Rear
B3M1036B
B2M3407
B3M1043
AT-43
12) Remove select cable nut.
13) Move gear select cable so that extension bolts
can be removed.
14) Remove bolts.
15) Remove extension case.
NOTE:
Use a container to catch oil flowing from extension.
16) Disconnect transfer duty solenoid connector.
17) Remove transfer duty solenoid and transfer
valve body.
(A) Transfer valve body
(B) Transfer duty solenoid connector
(C) Transfer duty solenoid
Automatic Transmission
G3M0308
B3M1044
B3M1045F