Subaru Legacy 2002 Service Manual page 1611

Automatic Transmission
B: INSTALLATION
1) Set the range select lever in "N" position.
2) Install the control valve and ground earth con-
nectors.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
(A) Short bolts
(B) Long bolts
3) Connect all connectors.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Transmission ground
CONTROL VALVE BODY
S502564A11
B3M1037A
B2M2263I
AT-40
4) Attach the magnet at the specified position.
5) Apply proper amount of liquid gasket to the
entire oil pan mating surface.
Fluid packing:
THREE BOND 1217B
6) Apply liquid gasket fully to 3 holes other than
screw holes on the transmission case.
Fluid packing:
THREE BOND 1217B
7) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
8) Pour ATF into the oil charge pipe.
Recommended fluid:
Dexron III type automatic transmission
fluid
Fluid capacity:
Fill the same amount of fluid drained
from drain plug hole.
B3M1105
B3M1040
B3M2265