OIL PUMP
Power Assisted System (Power Steering)
12) With knock pin positions aligned, install rear
cover.
Tightening torque:
27.5 N·m (2.8 kgf-m, 20.3 ft-lb)
CAUTION:
Loosely tighten bolts in the sequence (A), (B),
(C), and (D) shown in figure. Then, tighten in
the same sequence.
B4M1662B
13) When reassembly procedures have been
completed, turn shaft by hand to ensure it turns
smoothly. If it binds or other unusual conditions are
evident, disassemble again and check for foreign
matter trapped on sliding surfaces and improper
installation. Eliminate the cause of trouble.
14) Check followings by referring to "CHECK"
article.
¼ Excessive play in pulley shaft
¼ Ditch deflection of pulley
¼ Resistance to rotation of pulley
¼ Measurement of generated oil pressure
PS-80