Subaru Legacy 2002 Service Manual page 2074

7) Install boot projecting portion to shaft groove.
(A) Boot
(B) Small boot band
(C) Shaft
8) Tighten boot bands using ST, torque wrench
and socket flex handle.
ST 28099AC000 BOOT BAND PLIER
(A) Large boot band
(B) Boot
(C) Torque wrench
(D) Socket flex handle
(E) BJ
Tightening torque:
Large boot band
157 N·m (16.0 kgf-m, 116 ft-lb) or more
Small boot band
133 N·m (13.6 kgf-m, 98 ft-lb) or more
9) Place SFJ boot at the center of shaft.
10) Align alignment marks and install trunnion on
shaft.
FRONT DRIVE SHAFT
11) Install snap ring to shaft.
CAUTION:
Confirm that the snap ring is completely fitted
in the shaft groove.
12) Fill 100 to 110 g (3.53 to 3.88 oz) of specified
grease into the interior of SFJ outer race.
13) Apply a coat of specified grease to free ring
and trunnion.
14) Align alignment marks on free ring and trun-
nion and install free ring.
CAUTION:
B4M1297C
Be careful with the free ring position.
B4M0693C
15) Align alignment marks on shaft and outer
race, and install outer race.
16) Install circlip in the groove on SFJ outer race.
CAUTION:
Pull the shaft lightly and assure that the circlip
is completely fitted in the groove.
B4M0778
DS-29
Drive Shaft System
B4M0777
B4M0774