Tilt Steering Column - Subaru Legacy 2002 Service Manual

Hide thumbs Also See for Legacy 2002:
Table of Contents

Advertisement

1) Set the vehicle on the lift.
2) Disconnect battery minus ground cable.
3) Remove airbag module. <Ref. to AB-12,
REMOVAL, Driver's Airbag Module.>
WARNING:
Always refer to "Airbag System" before per-
forming airbag module service (if so equipped).
<Ref. to AB-12, INSPECTION, Driver's Airbag
Module.>
4) Remove steering wheel. <Ref. to PS-21,
REMOVAL, Steering Wheel.>
5) Lift-up the vehicle.
6) Remove universal joint. <Ref. to PS-22,
REMOVAL, Universal Joint.>
7) Lower the vehicle.
8) Remove trim panel under instrument panel.
9) Remove the screw securing lower steering col-
umn cover.
10) Remove all connectors from steering column.
11) Remove the two bolts under instrument panel
securing steering column.
12) Pull out steering shaft assembly from hole on
toe board.
CAUTION:
Be sure to remove universal joint before
removing steering shaft assembly installing
bolts when removing steering shaft assembly
or when lowering it for servicing of other parts.

TILT STEERING COLUMN

B: INSTALLATION
1) Set grommet to toe board.
2) Insert end of steering shaft into toe board grom-
met.
3) Tighten steering shaft mounting bolts under
instrument panel.
Tightening torque:
4) Connect all connectors under instrument panel.
5) Connect airbag system connector at harness
spool.
NOTE:
Make sure to apply double lock.
6) Install lower column cover with tilt lever held in
the lowered position.
7) Install
B4M1654
INSTALLATION, Universal Joint.>
8) Align center of roll connector. <Ref. to AB-19,
ADJUSTMENT, Roll Connector.>
CAUTION:
Ensure that front wheels are set in straight for-
ward direction.
9) Install
INSTALLATION, Steering Wheel>
Set steering wheel to neutral and install it onto
steering shaft.
CAUTION:
Insert roll connector guide pin into guide hole
on lower end of surface of steering wheel to
B4M1655
prevent damage. Draw out airbag system
connector, horn connector and cruise control
connectors from guide hole of steering wheel
lower end.
10) Install airbag module to steering wheel.
WARNING:
Always refer to "Airbag System" before per-
forming the service operation. <Ref. to AB-12,
INSPECTION, Driver's Airbag Module.>
PS-25
Power Assisted System (Power Steering)
S601544A11
25 N·m (2.5 kgf-m, 18.1 ft-lb)
universal
joint.
steering
wheel.
B4M1656
<Ref.
to
PS-22,
<Ref.
to
PS-21,

Advertisement

Table of Contents
loading

Table of Contents