Manual Transmission and Differential
3) Install transmission rear crossmember.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
4) Take off transmission jack.
5) Tighten nuts which hold lower side of transmis-
sion to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
6) Connect engine and transmission.
(1) Install starter.
<Ref. to SC-6, INSTALLATION, Starter.>
(2) Tighten bolt which holds right upper side of
transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
MANUAL TRANSMISSION ASSEMBLY
G2M0832
B2M2790
B2M2791
MT-34
7) Remove ST.
8) Install pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
9) Lift up the vehicle.
10) Install front drive shafts into transmission.
11) New drive spring pin into chamfered hole of
drive shaft.
G2M0313
H3M1839A
G2M0325