Subaru Legacy 2002 Service Manual page 1948

D: ASSEMBLY
S201105A02
1. FRONT BUSHING
1) Using ST-A, B, press bushing into rear arm.
ST-A, B 20099AE020 INSTALLER &
(1) Set ST-A in position with smaller inside
diameter side facing up.
(2) Set rear arm in position with outer side of
vehicle body facing down.
(3) Place bushing on upper side of rear arm.
(4) Place ST-B on upper side of bushing, then
press bushing into position.
CAUTION:
¼ Install bushing with painted side facing up.
¼ Install front bushing in the proper direction,
as shown in figure.
(1) Bushing
REAR ARM
S201105A0201
REMOVER SET
B4M1803A
B4M1802B
2. REAR BUSHING
1) Using ST-C, D and bearing puller, press bush-
ing into rear arm.
ST-C, D 20099AE040 INSTALLER &
(1) Insert bushing into bore in ST-D.
(2) Set ST-C, ST-D and bearing puller in
position, as shown in the figure, and press
bushing into position.
E: INSPECTION
Check rear arm for bends, corrosion or damage.
RS-13
Rear Suspension
S201105A0202
REMOVER SET
B4M1804B
S201105A10