Ip Igmp Access-Group - Allied Telesis x510-28GTX Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS
-
IP IGMP ACCESS GROUP

ip igmp access-group

Overview This command adds an access control list to a VLAN interface configured for IGMP,
IGMP Snooping, or IGMP Proxy. The access control list is used to control and filter
the multicast groups learned on the VLAN interface.
The no variant of this command disables the access control filtering on the
interface.
ip igmp access-group {<access-list-number>|<access-list-name>}
Syntax
no ip igmp access-group
Default By default there are no access lists configured on any interface.
Mode Interface Configuration for a VLAN interface.
Usage This command applies to VLAN interfaces configured for IGMP, IGMP Snooping, or
IGMP Proxy.
Example In the following example, hosts serviced by VLAN interface vlan2 can only join the
group 225.2.2.2:
awplus#
awplus(config)#
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
Parameter
<access-list-number>
<access-list-name>
configure terminal
access-list 1 permit 225.2.2.2 0.0.0.0
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Standard IP access-list number, in the range <1-99>.
Standard IP access-list name.
ip igmp access-group 1
1197