Hitachi Compute Blade 2000 User Manual page 306

Click a hard disk from disks displayed in Logical View or
Physical View, and the same screen is displayed as when
you select Drives > Properties from the menu.
Select a disk array from disks displayed in Logical View,
and the same screen is displayed as when you select
Virtual Drives > Properties from the menu.
 Setting items for MegaRAID WebBIOS
This section describes the setting items and values for MegaRAID WebBIOS.
The same alphanumeric characters are used to associate the setup screen

and each of the items.
In the table, the underlined values are Default values. Those in brackets [ ] are

recommended values.
Example:
[Enabled (valid)]/Disabled
recommended value.
[Enabled (valid)]/Disabled
"Enabled" is the recommended value, which requires a setting change.
When you need to change the setting from the Default to the recommended
value, the recommended value is emphasized in
Unless otherwise specified, use the recommended values
for all setting items. If you set non-recommended values,
the equipment is not supported and might not operate
properly.
(invalid): "Enabled" is the Default and also the
(invalid): "Disabled" is the Default value; and
red.
255