Hitachi Compute Blade 2000 User Manual page 313

Display item
P Spin Down Delay
Time *4
*1 This can be changed only when no disk arrays have been set at all.
*2 Do not use Set Factory Defaults. This setting must be changed to the recommended values.
*3 Change the value to the recommanded value.
*4 Always use the Default setting.
Firmware version; 2.120.233-1474 or later
Display item
A Battery Backup
B Coercion Mode *1
C Set Factory Defaults
*2
D S.M.A.R.T Polling *4
E Cluster Mode *3
F Alarm Control
G Rebuild Rate *3
H Patrol Read Rate *3
I BGI Rate *3
J Cache Flush Interval
*3
K CC Rate *3
L Spinup Drive Count *4 Number of hard disk motors to start
Display/content
Setting the saving mode to a hard
disk
Display/content
Battery backup unit mount status.
Setting the capacity control for the
physical hard disk used for disk
array building
Returning all the settings to their
Defaults values
Setting the interval of S.M.A.R.T.
reporting
Setting the cluster mode
Sounding the buzzer on the
controller in the event of a fault at a
connected device
Priority of rebuilding
Priority of patrol reading
Priority of background initializing
Flush timing for write-cache data
Priority of consistency inspection
262
Setting/display value **
0 to 1440 / [30]
Setting/display value **
None
[None (using the entire capacity)] /
128MB-way (using a capacity as a
multiple of 128MB) / 1GB-way
(using a capacity as a multiple of
1GB)
－
0 to 65535 / 300 / [600]
[Disabled (invalid)] / Enabled (valid)
[Disabled (not sounding)] / Enabled
(sounding) / Silence (stop sounding
temporarily)
0 to 100 / [30]
0 to 100 / [30]
0 to 100 / [30]
1 to 255 / [4]
0 to 100 / [30]
0 to 8 / [1]