Dot1X Mac-Auth-Bypass - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

show dot1x interface

dot1x mac-auth-bypass

Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity

Request frame, the system attempts to authenticate the host based on its MAC address.

dot1x mac-auth-bypass

To disable MAC authentication bypass on a port, use the no dot1x mac-auth-

bypass command.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

dot1x auth-type mab-only

Multi-supplicant mode authenticates every device attempting to connect to the

network on the authenticator port.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Introduced on the C-Series and S-Series.