Configure Wireless Ports Detected-Station-Timeout - Extreme Networks ExtremeWare Command Reference Manual

Wireless Commands

configure wireless ports detected-station-timeout

configure wireless ports [<portlist> | all] detected-station-timeout
<seconds>
Description
Sets the client current state age time-out value.
Syntax Description
portlist Specifies one or more ports or slots and ports. an be one or more port numbers. May be in the form
1, 2, 1:2, 3-5.
all Specifies all orts.
seconds Specifies the amount of time in seconds when the client current state table times out. Valid values are
between 60 to 3600.
Default
600 seconds
Usage Guidelines
Client aging allows you to configure an aging timer for wireless stations. When a specified period of
time elapses with no data traffic from the client to the Altitude 300, the client is de-authenticated and
removed from all client station tables for that interface. After a client is aged out, it can reassociate and
re-authenticate to the Altitude 300. Age-out information can be collected from such events as client
station failures, station idle-timeouts, or a client abruptly leaving the wireless network without notifying
the associated Altitude 300. The timeout value is configured for each port and affects both interfaces 1
and 2.
Example
The following command configures ports 13-24 to time-out the client current state table at 120 seconds.
configure wireless ports 13-24 detected-station-timeout 120
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p and Alpine switches.
1268 ExtremeWare 7.5 Command Reference Guide