Clear Gvrp; Set Garp Timer - Enterasys D-Series Cli Reference Manual

clear gvrp

Mode
Switch command, read‐write.
Examples
This example shows how to enable GVRP globally on the device:
D2(su)->set gvrp enable
This example shows how to disable GVRP globally on the device:
D2(su)->set gvrp disable
This example shows how to enable GVRP on fe.1.3:
D2(su)->set gvrp enable
clear gvrp
Use this command to clear GVRP status or on one or more ports.
Syntax
clear gvrp [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, GVRP status will be cleared for all ports.
Mode
Switch command, read‐write.
Example
This example shows how to clear GVRP status globally on the device:
D2(su)->clear gvrp

set garp timer

Use this command to adjust the values of the join, leave, and leaveall timers.
Syntax
set garp timer {[join timer-value] [leave timer-value] [leaveall timer-value]}
port-string
Parameters
join timer‐value
leave timer‐value
9-24 802.1Q VLAN Configuration
fe
.1.3
(Optional) Clears GVRP status on specific port(s). For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI" on
page 6‐1.
Sets the GARP join timer in centiseconds (Refer to 802.1Q standard.)
Sets the GARP leave timer in centiseconds (Refer to 802.1Q standard.)