Show Spantree Nonforwardingreason - Enterasys SECURESTACK C3 Configuration Manual

show spantree nonforwardingreason

show spantree nonforwardingreason
Use this command to display the reason for placing a port in a non‐forwarding state due to an
exceptional condition.
Syntax
show spantree nonforwardingreason port-string [sid sid]
Parameters
port‐string
sid sid
Defaults
If no port‐string is specified, non‐forwarding reason is displayed for all ports.
If no SID is specified, SID 0 is assumed.
Mode
Switch command, read‐only.
Usage
Exceptional conditions causing a port to be placed in listening or blocking state include a Loop
Protect event, receipt of disputed BPDUs, and loopback detection.
Example
This example shows how to display the non‐forwarding reason on ge.1.1:
C3(rw)->show spantree nonforwardingreason port
The non-forwarding reason for port
9-54 Spanning Tree Configuration
Specifies port(s) for which to display the non‐forwarding reason.
(Optional) Specifies the specific Spanning Tree(s) for which to display
the non‐forwarding reason. Valid values are 0 ‐ 4094. If not specified,
SID 0 is assumed.
ge.
1.1
ge.
1.1
on SID 0 is None