Oil Pressure Switch - Honda INTERCEPTOR 2002 Service Manual

LIGHTS/ METERS/ SWITCHES
REMOVALIINSTALLA TION
Disconnect the fan motor switch connector and
remove the switch.
Install a new 0-ring onto the fan motor switch.
Apply sealant to the fan motor switch th reads.
Install and tighten the fan motor switch.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
Install the removed parts in the reverse order of
removal.
OIL PRESSURE SWITCH
INSPECTION
20-18
If the oil pressure warning indicator stays on while
t he engine running, check the engine oil level before
inspection.
Make sure the oil pressure warning indicator comes
on with the ignit ion switch ON.
If the indicator does not come on, inspect as fo llow:
Remove the throttle body (page 5-63).
Remove the dust cover.
Remove the screw and oil pressure switch terminal.
Short t he oil pressure switch wire terminal to
ground using a jumper wire.
The oil pressure warning indicator comes on with
the ignition switch "ON".
If the light does not comes on, check the sub-fuse
(lOA) and wires for a loose connection or an open
circuit.
Start the engine and make sure that the light goes
out.
If the light does not go out, check the oil pressure
(page 4-5).
If the oi l pressure is normal, replace the oil pressure
switch (page 20-19).
FAN MOTOR SWITCH
OIL PRESSURE WARNING INDICATOR
l '
~,
I