Honda INTERCEPTOR 2002 Service Manual page 158

FUEL SYSTEM (Programmed Fuel Injection)
PGM-FI MIL 11 BLINKS (VEHICLE SPEED SENSOR)
1. Vehicle Speed Sensor Connection Inspection
Turn the ignition switch OFF.
Disconnect the vehicle speed sensor 3P connec-
tor.
VEH ICLE SPEED SENSOR 3P CONNECTOR
Check for loose or poor contact on the vehicle
:==================~
speed sensor connector. VEHICLE SPEED SENSOR 3P CONNECTOR
Connect the vehicle speed sensor connector.
Ride the motorcycle and keep the engine rpm
more than 5,000 rp m about 20 seconds or more.
Put t he side stand down, and check that the MIL
blinks.
Is the MIL blinking?
NO - Loose or poor contact on t he vehicle
speed sensor connector.
YES - GO TO STEP 2.
2. Vehicle Speed Sensor Power Input Line Voltage
Inspection
Turn the ignition switch OFF.
Disconnect the vehicle speed sensor 3P connec-
tor.
Turn the ignition switch ON.
Measure the voltage at the wire ha rn ess side.
Connection: Brown/blue (+) -Green /black (-)
Standard: Battery voltage
Does battery voltage exist?
No - • Open or short circuit in Brown/blue
wire of wire harness.
• Open or short circuit in Green/black
wire of wire harness.
YES -GO TO STEP 3.
VEHICLE SPEED SENSOR 3P CONNECTOR
5-23