Honda INTERCEPTOR 2002 Service Manual page 169

FUEL SYSTEM (Programmed Fuel Injection)
5-34
Check for loose or poor contact on the cam pulse
r------------------~
generator 2P connector. CAM PULSE GENERATOR 2P CONNECTOR
Connect the cam pulse generator 2P connector.
Place the motorcycle on its side stand.
Turn the ignition switch ON.
Turn the starter motor more than 10 seconds
and t hen check that the MIL blinks.
Check that t he MIL blinks.
Is the MIL blinking?
NO - Loose or poor contact on the cam pulse
generator 2P connector.
YES - GO TO STEP 2.
2. Cam Pulse Generator Short Circuit Inspection
Turn the ignition switch OFF and the engine stop
switch OFF.
Disconnect t he cam pulse generator 2P connec-
tor.
CAM PULSE GENERATOR 2P CONNECTOR
~
Check the continuity between the cam pulse
r------------------~
generator connector terminal and ground. CAM PULSE GENERATOR 2P CONNECTOR
Connection: White/yellow (+)-Ground (-)
Is there continuity?
YES - Fau lty cam pulse generator.
NO - GO TO STEP 3.
3. Cam Pulse Generator Peak Voltage Inspection
Crank the engine with the starter motor, and r------------------~
CAM PULSE GENERATOR 2P CONNECTOR
measure the cam pulse generator peak voltage
at t he cam pulse generator 2P connector.
Connection: Gray(+)- White/yellow(-)
Standard: 0.7
v
minimum (20 °C/68 °F)
Is the voltage at the standard value?
No - Faulty cam pulse generator.
YES -GO TO STEP 4.
; c::::J
0