Honda INTERCEPTOR 2002 Service Manual page 450

While aligning the splines, install the driven flange
assembly onto the rear axle.
Install the drive chain over the driven sprocket.
Install the air guide and collars, then tighten the
new bolts to the specified torque.
TORQUE: 9 N·m (0.9 kgf·m,
6.5
lbf·ft)
Install the brake hose clamp reta iner into the drive
chain case.
Route the brake hoses and rear wheel speed sensor
wire onto the drive chain case.
Install the brake hoses/rear wheel speed sensor wire
clamps and tighten the new screws securely.
REAR WHEEL/SUSPENSION
14-21