Honda INTERCEPTOR 2002 Service Manual page 498

When installing the
Dip the piston in brake fluid.
cups, do not allow
Install the spring to the primary cup.
the lips to turn
Install the spring/ primary cup and master piston/
inside out.
push rod assembly.
Be certain the snap
Install the snap ring using the special tool.
ring is firmly seated
in the groove.
TOOL:
Snap ring pliers 07914-SA50001
Install the boot.
If the push rod is disassembled, adjust t he push rod
length as shown.
After adjustment, tighten the lock nut to the speci-
fied torque.
TORQUE: 18 N·m (1.8 kgf·m, 13 1bf·ft)
INSTALLATION
HYDRAULIC BRAKE
PUSH ROD/ MASTER PISTON ASSEMBLY
SNAP RING SNAP RING PLIERS
LOCK NUT LOWER JOINT
Place the master cylinder between the muffler heat ,_ _ __ _______ _
guard and right footpeg bracket, install the master
cyli nder mounti ng bolts, collars and nuts.
15-31