Honda INTERCEPTOR 2002 Service Manual page 304

With the No.3 cylinder is at TDC, make sure the front
cylinder cam sprocket
"!::,!:::,.''
marks are facing out-
ward and flush with the top surface of the cylinder
head.
IF ONLY THE FRONT CYLINDER CAM-
SHAFT WAS REMOVED:
Remove the rear cylinder head cover (page 8-6).
Turn the cra nkshaft clockwise and align the "3T"
mark on the ignit ion pulse generator rotor with the
index mark on the right crankcase cover.
Make sure that the index lines on the rear cam
sprockets are facing outward.
If they are not, turn the crankshaft clockwise one full
turn (360°) and realign the "3T" mark with the index
mark.
Turn the crankshaft clockwise 1-1/4 turn (450°) and
align the "4T" mark on the ignition pulse generator
rotor with the index mark on the right crankcase
cover.
CYLINDER HEAD/ VALVES
l
8-41