Honda INTERCEPTOR 2002 Service Manual page 327

CLUTCH
Coat all parts with clean brake fluid before assem-
bly.
Dip the piston in brake f luid.
Install t he primary and secondary cups onto the
master piston.
When installing the
Install the spring and master piston assem bly into
cups, do not allow
t he master cylinder.
the lips to tum
inside out.
Be certain the snap
Install the snap ring using the special tool.
ring is firmly seated
in the groove.
TOOL:
9-10
Snap ring pliers 07914-SA50001
Apply silicone grease to t he boot inside and t ip of
the push rod.
Install the push rod and boot.
Apply silicone grease to the top of the push rod.
Install t he clutch lever assembly by aligning the hole
of the joint piece w ith the tip of the push rod.
PISTON ASSEMBLY
~ ~
SPRING
SNAP RI NG
JOINT PIECE