Fuel Cut-Off Relay - Honda INTERCEPTOR 2002 Service Manual

FUEL SYSTEM (Programmed Fuel Injection)
FUEL FLOW INSPECTION
Remove the upper cowl (page 2-12).
Open and support the fuel ta nk using the equipped
tools (page 3-5).
Disconnect the fuel cut-off relay connector.
Jump the Brown and Black/white wire terminals of . - - - -- -- - - - -- - -- - - - - ,
the wire harness side using a jumper wire. FUEL CUT-OFF RELAY
• When the fuel return hose is disconnected, gaso-
line will spill out from the hose. Place a approved
gasoline container and drain the gasoline.
• Wipe off spilled out gasoline.
Disconnect the fuel return hose at the fuel tank, plug
the fuel tank inlet joint.
Turn the ignition switch ON for 10 seconds.
Measure the amount of fuel flow.
Amount of fu el flow:
150 cm
3
(5.0 US oz, 5.3 Imp oz) minimum
/10 seconds at 12 V
If the fuel flow is less than specified, inspect the fol-
lowing:
- Pinched or clogged fuel hose and fuel return
hose
- Clogged fuel filter
- Pressure regulator
- Fuel pump (page 5-54)
After inspection, connect the fuel return hose.
Start the engine and check for leak.
JUMPER WIRE
CONNECTOR
FUEL RETURN HOSE
5-53