Primary Drive Gear - Honda INTERCEPTOR 2002 Service Manual

Install the clutch lifter rod into the mainshaft.
Apply grease to the tip of the lifter rod and install
the clutch lifter piece into the mainshaft.
Install the lifter bearing into the pressure plate.
Install the pressure plate.
Inst all the clutch springs and spring bolts.
T ighten the bolts in a crisscross pattern in 2 - 3
steps, then tighten the bolts to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 91bf.ft)
Install the right crankcase cover (page 9-25).
PRIMARY DRIVE GEAR
REMOVAL
Remove the starter clutch assembly (page 19-11 ).
Remove the primary drive gear guide from the
crankshaft.
Remove the primary drive gear from the crankshaft
while aligning the sub-gear teeth with the primary
drive gear teeth with a screwdriver.
CLUTCH
9-23